Page 1 of 1

Kat's Magic Tower (builder40)

Posted: August 25th, 2011, 8:22 am
by eKatsie
Well, I made this in builder40 because I like towers for some reason, lately. It's a magician's tower. It can be found very close to the spawn point.

Front Exterior: http://i617.photobucket.com/albums/tt25 ... 011133.png

Back Exterior: http://i617.photobucket.com/albums/tt25 ... 011419.png

First Floor Interior: http://i617.photobucket.com/albums/tt25 ... 011151.png

Middle Floor Interior: http://i617.photobucket.com/albums/tt25 ... 011228.png

Top Floor Interior: http://i617.photobucket.com/albums/tt25 ... 011326.png

Looking Up from Bottom to Top Interior: http://i617.photobucket.com/albums/tt25 ... 011204.png

This one took a while... I did not use any commands and I'm proud of the work I've put into it! I'm not the most experienced builder, so this is practice for trying to get better. I'm starting to like building more. I may add more to it later.

Re: Kat's Magic Tower (builder40)

Posted: August 25th, 2011, 9:04 am
by barrowboyjames
James likey a LOT! You have talent, spend a bit more time on them and enlarge them and you'll be the best builder I've seen!

Re: Kat's Magic Tower (builder40)

Posted: August 25th, 2011, 9:39 am
by Freeze_Craft
Overall it could use a bit more detail, but considering you're a new builder, this is impressive. Good luck for your future builds, I'll be sure to keep an eye out.

Re: Kat's Magic Tower (builder40)

Posted: August 27th, 2011, 2:31 am
by eKatsie
Thanks. Any advice on how to give these sort of builds more of a 'detailed' look? Varying block shades for the tower exterior, perhaps?

Re: Kat's Magic Tower (builder40)

Posted: August 27th, 2011, 6:10 am
by Fehzor
Rounding corners is good, as is replacing some of the blocks with similar blocks and making patterns.